Design your own

The birdsmouth cut

A birdsmouth is the notch near the bottom of a rafter that lets it sit flat on the wall's top plate. It has two faces: the seat, which rests on the plate, and the heel, the plumb cut that bears against the outside of the wall.

How big should it be?

The seat needs at least 1-1/2″ of bearing. The common rule of thumb keeps the heel to no more than a third of the rafter's depth, so a 2x6 rafter keeps at least two thirds of its wood above the notch. On a 6/12 roof, a 1-1/2″ seat makes a 3/4″ heel.

Why plans check more than the rule of thumb

A notch at the end of a rafter concentrates shear at its inside corner. The National Design Specification for wood reduces a notched member's shear capacity by the square of the depth left over the notch, so a deep notch loses strength quickly. Every plan on this site runs that check for each rafter and hip. When a notch fails, the builder steps the rafter up a size or doubles the hip.

Hip rafters

Hips are deeper than the common rafters, so their birdsmouth is deeper too. That's why gazebo plans here often call for a doubled hip.

Laying one out

  1. Set a speed square to the roof pitch on the rafter's face and draw the plumb line where the rafter crosses the outside of the wall.
  2. Measure the seat length square off that line, 1-1/2″ or the wall depth.
  3. Cut both lines with a circular saw, stopping at the corner, and finish with a handsaw so you don't overcut.

Rafter length calculator