Rafter length calculator
Enter the building width, pitch and overhang. You get the full rafter length along the top edge, where the birdsmouth goes, and the plumb cut angle.
How it's worked out
The run is half the building width minus half the ridge board for a gable, or the width minus the wall depth for a lean-to. Divide the run by the cosine of the roof angle to get the length along the slope. The overhang is added the same way. The birdsmouth seat here is 1-1/2″, the minimum bearing, which keeps the notch shallow.
Rafter lengths by width and pitch
Gable roof, 1-1/2″ ridge, 12″ overhang, measured along the top edge from the ridge plumb cut to the tail.
| Building width | 3/12 | 4/12 | 5/12 | 6/12 | 8/12 | 10/12 | 12/12 |
|---|---|---|---|---|---|---|---|
| 6′ | 48-11/16" | 49-13/16" | 51-3/16" | 52-13/16" | 56-13/16" | 61-1/2" | 66-13/16" |
| 8′ | 61-1/16" | 62-7/16" | 64-3/16" | 66-1/4" | 71-3/16" | 77-1/8" | 83-13/16" |
| 10′ | 73-7/16" | 75-1/8" | 77-3/16" | 79-11/16" | 85-5/8" | 92-3/4" | 100-3/4" |
| 12′ | 85-13/16" | 87-3/4" | 90-3/16" | 93-1/16" | 100-1/16" | 108-3/8" | 117-3/4" |
| 14′ | 98-3/16" | 100-3/8" | 103-3/16" | 106-1/2" | 114-1/2" | 124" | 134-11/16" |
| 16′ | 110-9/16" | 113-1/16" | 116-3/16" | 119-15/16" | 128-7/8" | 139-5/8" | 151-11/16" |
| 20′ | 135-5/16" | 138-3/8" | 142-3/16" | 146-3/4" | 157-3/4" | 170-7/8" | 185-5/8" |
| 24′ | 160" | 163-5/8" | 168-3/16" | 173-9/16" | 186-9/16" | 202-1/16" | 219-9/16" |